ABB RETA-02, User Manual

Page: 19 / 112

Quick start-up guide
19
Quick start-up guide
Overview
This chapter presents the steps to take during the start-up of the
RETA-02 Ethernet Adapter module. For more detailed information,
see chapters
Mechanical installation , Electrical installation ,
Network configuration , Master configuration and Communication
elsewhere in this manual.
WARNING! Follow the safety instructions given in this manual and
the Hardware Manual of the drive.
Mechanical installation
• Insert the RETA-02 into its specified slot in the drive (SLOT2 for
ACS550, SLOT1 for ACS800).
• Fasten the two screws.
Electrical installation
• Connect the Ethernet network cable (RJ-45 connector) to the
RETA-02 module. Standard CAT 5 UTP or STP cables can be
used. Avoid parallel runs with power (e.g. motor) cables.
Drive configuration
• Power up the drive. In Modbus/TCP mode the “MODULE
STATUS” LED should be green. If the network cable is
connected to an active network, the green “LINK/ACTIVITY”
LED should also be lit or blinking. In PROFINET IO mode the
“MODULE STATUS” led should be blinking red because the
name of the device has not been assigned yet.
• The detailed procedure of activating the drive for
communication with the module is dependent on the drive type.
Normally, a parameter must be adjusted to activate the