ABB OmniCore C30, Product Manual

Page: 42 / 606

Power supply
Value Mains
220/230 VAC, 1 phase Voltage for OmniCore C30
100-230 VAC, 1 phase
i
+10%, -15% Voltage tolerance
+10%, -10%
i
50/60 Hz Frequency
±3% Frequency tolerance
i
For IRB 14050 controller and CRB 15000 controller.
Note
The 2 phases (180-degree phase shift, with grounded neutral), also called
Single-phase three-wire system in North America, can be supported by this
controller.
Load current
There is no integrated fuse inside the OmniCore C30 controller. Add an external
fuse (time-delay) or circuit breaker (class K) according to full load current, as
marked on the controller nameplate. The following table shows the recommended
rating for an external fuse or circuit breaker.
Add an external circuit breaker (class K) according to full load current, as marked
on the controller nameplate. The following table shows the recommended rating
for an external fuse or circuit breaker.
Description Current (A) Robot
10 A 220/230 VAC, 1 phase IRB 1100
10 A 220/230 VAC, 1 phase IRB 1200
10 A 220/230 VAC, 1 phase IRB 1300
10 A 220/230 VAC, 1 phase IRB 910INV
10 A 220/230 VAC, 1 phase IRB 920
10 A 220/230 VAC, 1 phase IRB 360
6 A 100-230 VAC, 1 phase IRB 14050
10 A 220/230 VAC, 1 phase CRB 1100
16 A in 100 VAC 100-230 VAC, 1 phase CRB 15000
6 A in 230 VAC
Residual current
An external earth fault protection (residual current device, RCD) is required based
on the following data:
Residual Current in controller (mA) Robot
< 30 mA IRB 1100
< 30 mA IRB 1200
Continues on next page
42 Product manual - OmniCore C30
3HAC060860-001 Revision: P
© Copyright 2019-2022 ABB. All rights reserved.
2 Controller description
2.2 Technical data for OmniCore C30 controller
Continued