ABB FS4000, Operating Instruction

Page: 63 / 126

Parameterization
D184B097U02 FV4000 / FS4000 63
8.2 Operation using the control buttons on the transmitter
G00718
C/CE
Step
Step
C/CE
Data
Data/
Enter
Enter
1
2
3
Fig. 46: Position of control buttons and magnet sensors
1 Control buttons
2 Magnet sensors
3 Rotating display panel
Control buttons
To enter data with the housing cover removed, use the three control buttons "Data", "Step", and
"C/CE" at the top of the display panel.
Control
button Function
C/CE Press the "C/CE" control button to change from the operating mode to the menu
and vice versa.
Step The "Step" control button is one of two arrow buttons. Press "Step" to move
forward through the menu. All required parameters can be called up.
Data The "Data" control button is one of two arrow buttons. Press "Data" to move
backward through the menu. All required parameters can be called up.
Enter The "Enter" function requires that both arrow buttons, "Step" and "Data", be
pressed simultaneously. The "Enter" function activates and deactivates
programming protection. It can also be used to call up further parameters for
modification and apply new, selected or set parameters.
The "Enter" function can also be activated by pressing and holding down just the
"Data" control button for more than 3 s. The display flashes to indicate that this
function is active. As soon as the control button is released, the "Enter" function is
executed.
If, following execution of the "Enter" button, no more entries are made for approx.
10 s, the display will revert to the previous value. After another 10 s without any
entries, the process information will reappear.