ABB ACS850-04 series, Firmware Manual

Page: 21 / 296

The ACS850 control panel 21
„
Output mode
In the Output mode, you can:
• monitor actual values of up to three signals
• change the direction of the motor rotation
• set the speed, frequency, torque or position reference
• adjust the display contrast
• start, stop, change the direction and switch between local and remote control.
You get to the Output mode by pressing repeatedly.
The top right corner of the display shows the
reference value. The center can be configured to
show up to three signal values or bar graphs; see
page
29 for instructions on selecting and modifying
the monitored signals.
How to change the direction of the motor rotation
How to set the speed, frequency, torque or position reference in the Output
mode
See also section Reference Edit on page 48 .
Step Action Display
1. If you are not in the Output mode, press repeatedly
until you get there.
2. If the drive is in remote control (REM shown on the status
line), switch to local control by pressing
. The display
briefly shows a message about changing the mode and
then returns to the Output mode.
3. To change the direction from forward ( shown on the
status line) to reverse ( shown on the status line), or
vice versa, press
.
Step Action Display
1. If you are not in the Output mode, press repeatedly
until you get there.
EXIT
50
A
10
Hz
7
%
10.
0.
49.
LOC
DIR MENU 00:00
30.00rpm
EXIT
50
A
10
Hz
7
%
10.
0.
49.
REM
DIR MENU 00:00
30.00rpm
LOC
REM
50
A
10
Hz
7
%
10.
0.
49.
LOC
DIR MENU
00:00
30.00rpm
DIR
EXIT
50
A
10
Hz
7
%
10.
0.
49.
REM
DIR MENU 00:00
30.00rpm