Zontes ZT125-M 2022, Руководство по обслуживанию

Страница: 129 / 218

129
/
218
plug close to the engine cylinder head cover or box (should
be far away from the spark plug mounting screw hole)
about 6mm (0.24 in), press the start button. If a blue spark
is found on the spark plug electrode, the ignition system is
normal, otherwise it should be inspected by a qualified
maintenance unit.
If you replace the ignition coil, follow the steps below:
a. Put down the lef rear pedal and use the 4# inner
hexagon to remove the M6×14 bolt.
b. Pull out in sequence in the direction of the arrow
(from the rear wheel to the front wheel). Note that there
are 5 staples at the red circle and a circle of buckles around.
Need to use a lot of force to pull out.
c. Use 4# inner hexagon to remove 2 M6×14 bolts.
Starting from the bottom where the left cover plate of the
fuel tank and the tail skirt intersect, pull the left cover plate
outward with one hand and press the front part of the tail
skirt with the other hand; pull out the upper part of the left
cover plate after pulling out the bottom. Then grasp the
middle of the cover, press down the back of the cover and
pull out the left cover at the same time.
d. Refer to the section "Maintenance-Removal of Spark
Plug" to remove the left pedal. Steps are not repeated
here.
e. ignition coil
M125/310
Unplug the ignition coil connector, pull out the high-
pressure cap at the spark plug and use a Phillips
screwdriver to remove the two M5×16 bolts ⑹ , cut the
cable tie ⑺ and then remove the ignition coil.
M350
Refer to the previous 310 steps and disassemble it to the
following figure.
Remove the left cable tie and pull out the high pressure
cap at the spark plug.
Hold the ignition coil body with one hand, and press the
anti falling snap of the plug at the arrow with the other
hand to pull out the plug. Since it is difficult to pull out the
waterproof rubber plug in the plug, be careful not to break
the plastic bracket.
Remove M6×12 bolts with 4 # socket head, remove the
ignition coil and bracket assembly from the vehicle. remove
the two M6x22 bolts with an 8# sleeve, and then remove
the ignition coil body and the high voltage wire assembly.
Unplug the high voltage wire from the ignition coil body.