52 / 218
3. Replace the air inlet filter element
a. Use a Phillips screwdriver to remove the four tapping
nails delivered with the air intake sponge filter assembly.
Remove the air intake sponge after removing the front shell.
Install the front shell back after replacing with new sponge.
Pay attention to install the screws vertically and the torque
should not be too large. The air intake sponge filter element
is replaced every 4000 km (2485mile) or 15 months
(whichever is reached first).
b. Remove the sponge and replace it with a new filter
element. Note that the black side faces the engine and the
white side faces out.
4. Remove the air filter shell
a. Push 2 pieces of decorative glue inside the air filter with
4# hex.
b. Use a Phillips screwdriver to remove the two tapping
nails.
c. Use a Phillips screwdriver to remove the four screws that
secure the cover of the air filter.
d. Remove the shell of the air filter.
e. Place the rubber plug and tapping nail properly to avoid
loss.
5. Replace the filter element of the air filter
a. Use a Phillips screwdriver to remove the six screws used
to secure the filter element from the air filter.
b. Remove the old empty filter element. Use the dust
blower gun to clean the dust inside the inlet pipe and then
wipe the inner wall clean with a clean non-woven cloth.
c. Replace the filter element and seal with a new one.
6. Check the waste oil pipe of air filter
After removing the rubber plug, use a flashlight to polish it
from the bottom according to the arrow direction, and
observe whether the waste oil drain pipe accumulates dirt or
water through the rubber plug hole.If yes, use pliers to
remove the waste oil pipe clamp ①, pu
ll out the black plug,
and then install it again after draining the waste oil or
sewage.Pay attention to increase the inspection frequency
when the air humidity is high. If there is too much dirt in the
hose, be sure to check whether there is too much dirt or
damage in the air filter element, and replace the air filter
element if necessary.
Содержание ZT125-M 2022
