Zontes ZT125-M 2022, Руководство по обслуживанию

Страница: 213 / 218

213
/
218
Disassembly of tail light
a. Remove the two M6x14 bolts on the left part of the
bottom plate of the tail cover by 4# inner hexagon. Remove 1
ST4.2×12 screw on the left part of the tail skirt bottom plate
by 5# inner hexagon. Grab the left part of the tail skirt
bottom plate and pull it in the direction of the big arrow to
remove the left part of the tail skirt bottom plate.
b. Use the same method to remove the right side of the
tail-cover board.
c. Use 4# inner hexagon to remove the 2 swell nails which
connected to the rear clay board with the taillight
d. Find out and unplug the taillight plug (3P) from the
plastic cover on the left side of the frame, hold both ends of
the taillight and pull it out diagonally in the direction of the
arrow to remove the taillight.
e. 4 Hold the taillight cover with one finger, and push
the cover latch with your thumb in the direction of the
arrow. Push the buckle on the other side away in the same
way. After pushing the buckles on both sides open, hold the
tail light with one hand, and push the middle of the grip
cover upwards with the other hand. Separate the cover and
taillights. Note that there is a friction button in the middle, so
it takes a lot of force to break it apart.
Disassembly of rear fender
a. Use the 4# inner hexagon to remove the 4 M6x14 bolts
(which connecting the rear inner clay plate to the frame).
b. Find out and unplug the joint of rear license plate light,
left and right turn signal and rectifier from the rubber cover
on the left side of the frame.
c. One person uses 14# sleeve to fix the non-standard
M10×1.5×55 bolt from upper of the rear shock absorption,
one person uses 14# ratchet wrench or box wrench
to remove the non-standard M10×1.5 nut, from the upper
part of the rear shock absorption of the frame inside; nut
torque: 30N.m
（
3.1 kgf.m, 22 lbf.ft
）
.Remove nuts on the
other side using the same method.Two bolts can not be
removed.