Zontes ZT125-M 2022, Руководство по обслуживанию

Страница: 215 / 218

215
/
218
washer. After holding the rear reflector ② firmly, use a 10#
sleeve to remove the nut and washer that comes with it.
k. If you need to replace the rear fender, you need to
remove 4 pieces of plywood nuts, 1 piece of side cover
rubber and 1 piece of rear license plate buffer glue. Note that
the rear license plate buffer is pulled out to the side where
the rear license plate is installed.
Disassembly of the left, right fuel tank
cover
a. Remove a non-standard M6x14 bolt on the right part of
the fuel tank cover with 4# inner hexagon. Grasp the mark on
the right part of the fuel tank cover (green rectangle) and
pull it upward in the direction of the arrow Until the right
part of the tank cover plate and the middle part of the tank
cover plate (yellow area) (The middle cover is gray, and the
right part of the fuel tank cover is red.) of the 4 buckle
positions separated.
b. Grasp the mark (green rectangle) of the right cover part
of the fuel tank and pull it out in the direction of the arrow
until the two buttons (blue circles) on the fuel tank cover are
pulled out, then remove the right fuel tank cover.
c. Remove the left part of the fuel tank cover by the same
method.
Disassembly the middle cover of the fuel
tank
a. Use the 4# inner hexagon to remove the 2 M6x14 bolts
fixed in the middle of the cover plate of the fuel tank.
b. Connect the positive and negative terminals of the main
wiring harness of the battery to open the tank lock or open
the tank lock before removing the battery; Remove the
M6x16 bolt fixing the oil tank cover with the 4# inner
hexagon, and unscrew the threaded oil tank
c. Find out and unplug the tank lock connector under
the cushion stand and make the tank lock wire harness well.