Zontes ZT125-M 2022, Руководство по обслуживанию

Страница: 196 / 218

196
/
218
tightened or cannot be penetrated into the right shock
absorbers. Remove the shock absorbers that are not installed
in place and install them in place.
e. After the front wheel is installed, use 6# hex to tighten
the two M8×35 bolts at the lower part of the right front
shock absorption, and the torque force is 20N.m (2.0 kgf.m,
15 lbf. ft).
f. Use a slotted screwdriver to separate the brake pads
inside the brake caliper. If the resistance is too great to
separate the two brake pads, remove the upper cover of the
disc brake oil cup and then separate the two brake pads.
Align the gap between the two brake pads in the disc brake
caliper with the brake disc on the front wheel before
installing. Then use 8# hex to tighten 2 M10×1.5×60 bolts,
torsion force: 45 ~ 50N.m(4.6 ~ 5.1 kgf.m, 33 ~ 37 lbf. ft).
g. Press and hold the position held when removing the
front mud pan, pass through the proper position in the
middle of the shock absorber, and install it to the
corresponding position, and then use the 4 # hexagonal
socket to insert 2 pieces of M6 × 14 shaft shoulder bolts.
Then install the 2 M6x30 bolts back with 5# hex. Note: the
M6x30 bolts on the left should be equipped with gaskets.
M125/310 replace the lower link board
Caution:
●After the front wheel is disassembled, please do not press
the brake handle.
●When the disc brake oil cup is removed, it must be vertically
upward to prevent air from entering the brake pipeline.
●After disassembly, make sure that all parts are installed
correctly.
●Appropriate amount of grease should be applied when
installing the bearing.
●The M125 steps are similar to the M310, taking the M310 as
an example.
1. Disassemble parts ahead of time
Refer to "Replace the front wheel", "Replace the front
shock absorber", "Replace the steering handle", and remove
the front wheel, front shock absorber, and direction handle.
2. Remove the faucet lock
a. Turn on the vehicle, press the 2 front storage box
switches at① to open the left and right storage boxes.
b. Use 4# inner hexagon to remove 4 M6×14 bolts, and 2
M6×16 bolts; then use 4# inner hexagon or other tools to
remove The two swell nails on the lower storage box, take
out the left and right storage boxes, the left storage box has a
line connection, do not pull it vigorously, just place the foot
pedal.
c. Extend the 10# torx wrench from the gap in the storage
box, remove the two M6×20 bolts on the faucet lock support,
remove the faucet lock and faucet lock support, no need to
connect the faucet lock and the faucet Remove the lock and
put it in a suitable place next to it.
Left
Right
3. Removing the direction pad
a. Take out the handle switch harness and brake hose in
the direction wire clip from the direction of the wire clip gap
one by one, until the direction is taken out all the wire
harnesses in the wire clip, and then use the 4# inner hexagon
to remove the M6×12 bolt that fixed direction wire, take out
the direction of the wire clamp.
b. Use a ratchet extension rod + 30# sleeve to
remove the upper link plate cover nut.