Zontes ZT125-M 2022, Руководство по обслуживанию

Страница: 77 / 218

77 / 218
Remove the swell nail. For instructions on disassembly and
assembly of swell nails, please refer to the pre-service
instructions in this chapter.
Grasp the upper part of the storage box with one hand,
and remove the bottom M6×16 bolt with the 4# inner
hexagon with the other hand.
b. Remove the right storage box assembly from the car.
c. Open the cover of the Coolant expansion tank, and add
coolant to the Coolant expansion tank with the help of a
funnel, paying attention to adding a small amount to
between "H" and "L" several times.
M350
a. Put down the right rear foot and remove the M6x14 bolt
using the 4# hex socket.
b. Pull it out in the arrow direction (from the rear wheel to
the front wheel). Notice that there are 5 pins in the red circle
with a buckle around them. It takes a lot of force to pull it
out.
c. Open the rubber cover of the auxiliary water tank, and
add an appropriate amount of coolant with the aid of a
funnel. Hold the vehicle upright and observe whether the
liquid level in the auxiliary water tank is between "H" and "L"
with the help of a flashlight.
Pay attention to the flatness and levelness of the ground
as much as possible, and do not check it on the slope. And
the engine must be cold.
3. Add coolant to the Radiator
M125/310
a. Refer to the above steps to remove the right storage
box assembly.
b. Unscrew the Radiator filler cap indicated by the arrow.
c. Use a 10# sleeve to loosen the thermostat bleed bolt (5)
counterclockwise by 4 to 5 turns, do not completely remove
it. Note that a small container is required to receive the
coolant overflowing from the exhaust bolt. Do not allow the
coolant to drip directly onto the surface of the part.
d. Put on waterproof gloves and add coolant to the water
inlet of the Radiator with the help of an extended funnel.
Until the position of the vent bolt of the thermostat is stably