Zontes ZT125-M 2022, Руководство по обслуживанию

Страница: 49 / 218

49 / 218
●The air filter element and the engine air inlet element
should be cleaned regularly in accordance with the provisions
of the regular maintenance and lubrication table.
●If you often ride in humid or dusty areas, you should check
the air filter element more frequently. Be sure to inspect the
waste oil pipe of the air filter frequently.
●If the filter elem ent is damaged, it must be replaced, and
otherwise the dirt will be directed into the engine and cause
damage to the engine.
●Ensure that the filter element is assembled in place.
●If the air filter is clogged with dust, the air intake resistance
will increase and the output power will decrease.
●If the filter element of the engine air intake is blocked by
dust, the air intake resistance will increase, which will reduce
the heat dissipation of the belt and affect the life of the belt.
●If the replacemen t period is not reached, the surface of the
filter element is clean without damage, and you can use a
dust blow gun to blow air from the clean side of the filter
element to blow away the dust on the surface of the filter
element.
●Do not let water enter th e air filter when washing the
vehicle.
M125 Air filter (filter element), air inlet
filter element
Step
：
1. Support the vehicle firmly
Prop up the vehicle with the main bracket and put down
the side brackets, as shown in the figure.
2. Remove the left engine cover
a. Use your fingers to pull out the decorative buckle.
Use 4# inner hexagon to remove the M6×14 bolt as shown
in the figure. The bolt here cannot be removed temporarily,
just loosen it completely.
b. Use 4# inner hexagon to press down the center
cylindrical pins of the 2 swell nails, and then remove the swell
nails and the engine rear decorative cover.
c. Use 4# inner hexagon to remove the 4 pcs Hexagon
socket head screw M6×14 bolts as shown in the figure.
d. Remove the front part of the left engine cover. The bolts
removed in the second step will fall off at this time.
3. Replace the air inlet filter
Use a corss screwdriver to remove the 4 self-tapping
screws that come with the air inlet sponge filter assembly.
Remove the air inlet sponge after removing the front cover.
After replacing the new sponge, put the front shell back, pay
attention to the screws should be installed vertically and the
torque should not be too large. The air inlet sponge filter
should be replaced every 4000 kilometers (2485 miles) or 15
months (whichever comes first).
b. Remove the sponge and replace it with a new filter
element. Note that the black side faces the engine and the
white side faces outward