Zontes ZT125-M 2022, Руководство по обслуживанию

Страница: 98 / 218

98
/
218
2pcs φ10.5×φ24×2 gasketes . Some of the vehicles earlier did
not have gasketes.
b. Remove the rubber cover then one person pinches the
rear brake handle, and one person uses 21# impact
wrench to remove the rear wheel M16×1.5 nut. Standard
torque of nut: 125N.m (12.8 kgf.m, 92 lbf.ft).
c. Use 4# hex socket to remove the M6×14 bolt ⑵ on the
right middle of the rear inner mudguard, use 4# hex socket to
remove the front M6×12 bolt ⑴ and the rear M6×16 bolt.
Remove the two M6×12 bolts ⑴ and M6×16 bolt at the
bottom of the rear rocker arm, and remove the wheel speed
sensor. Pull out the staples on the position indicated by the
arrow and remove the decorative cover of the engine right
cover.
d. In the gap between the left air filter and the rear inner
mud board, hold the air filter housing with one hand, and
press the rear inner mud board at the position 2 indicated by
the arrows with the other hand. Separate the rear inner mud
plate from the staples on the air filter and lift it up to
facilitate subsequent removal of the rear rocker arm.
e. Use a 14# sleeve to remove the 2 bolts that fix the rear
brake caliper, and tie the caliper and the wheel speed sensor
cable. Pay attention to let the calipers sag naturally without
affecting the rocker arm after disassembly. Use a 14# sleeve
to loosen the 2 bolts. Then use a 12# sleeve to remove the
bolt that fixes the rear shock absorber, and then remove the
rear shock absorber and tie it. Grasp the rear rocker arm
firmly with one hand, and remove the 2 bolts with the other
hand. Pull the rear rocker arm outwards and remove the rear
rocker arm, paying attention not to omit the shaft sleeve
when reinstalling. Standard torque of bolt: 45N.m (4.6 kgf.m,
33 lbf.ft); bolt and are 24N.m (2.4 kgf.m, 18 lbf.ft).
f. Remove the shaft sleeve and take off the rear wheel
assembly.
g. Replacing the rear brake disc
M310:Remove bolts with 6# inner hexagon soket, and then
take off the brake disc. If you need to replace the ABS gear
ring, remove the bolt and then replace it. Bolt standard
torque: 25N.m (2.6 kgf.m, 18 lbf.ft).
M125:
h. Refer to the order of disassembly to restore. Note that
bolts with torque requirements need to be calibrated
according to standard values.
Brake hose
Caution:
●This inspection should be completed by a qualified
maintenance organization.
●Check the hhose according to the maintenance schedule.
●It is recommended to replace the brake hose every 4 years.
Refer to steps 1 and 2 of checking brake fittings in the
brake system, you can use the endoscope with LED to easily
check the oil pipe joints of the ABS hydraulic control unit and
the main pump, or remove the corresponding cover for
inspection.