Zontes ZT125-M 2022, Руководство по обслуживанию

Страница: 55 / 218

55 / 218
d. Respectively use 4# inner hexagon to remove the 2
M6×12 bolts at the front pedal.
e. Use 4# inner hexagon to remove the 3 M6×14 bolts that
surround the left side(1).
f. Use your fingers or a plastic crowbar to forcefully break
out from the arrow point until the bolt near the arrow point
is exposed. Because there are still bolts on the upper part
that have not been removed, it cannot be removed directly.
g. Use 5# inner hexagon to remove M6×14 bolt, then
remove bushing.
h. Use 4# inner hexagon to remove 7pcs M6×14 bolts.
i. Use 4# inner hexagon to press down the center
cylindrical pins of the 4 swell nails on the left, and then
remove the swell nails. Remove the bolt on the left front part
with a 4# inner hexagon for instructions on disassembly and
assembly of swell nails, please refer to the pre-service
instructions in this chapter. M310 vehicles produced before
May 18, 2022 have 4 expansion nails on the left side, and
vehicles after that have 3 expansion nails; those produced on
May 18 should be distinguished.
j. Press the blue part inward at the junction of green and
blue as shown in the figure; pull the red and green
components outward. Then apply force from the rear wheel
to the front wheel along the junction of the red and blue
parts, push the red part outwards, and force the blue parts
inward to break apart. Remove the left pedal and left pedal
trim cover assembly.
k. Use a dust blow gun to blow away the dust and debris
near the spark plug.
l. Pull out the ignition coil high-voltage cap.
m. Remove the spark plug by turning it counterclockwise
with the vehicle-mounted tool or special 14# spark plug
sleeve.