9
Building jig attached to bench.
We use nails to secure the jig.
All bulkheads on position.
Keel halves before being laminated.
Building Jig
Sand both sides of the jig.
Attach the jig to your FLAT bench with screws,
nails, clamps or whatever you need, to make
sure it’s attached to the surface.
Make sure the “F” is so that you can read it.
Remove bulkheads 1, 2 and 3.
Sand the edges with 80 grit to remove the fuzz,
as well as the little tabs that held them in the
sheet.
Put bulkheads 1, 2 and 3 into the jig, engaging
the tabs in the slots.
Starting from the front of the jig, glue the tabs of
bulkhead 1 to the jig.
Use a square to ensure that it’s 90 degrees to
the jig. Also make sure that the tabs don’t
protrude under the jig.
Use CA and accelerator.
When dry and square, glue bulkheads 2 and 3
to the jig the same way. Use the square.
Remove sand and glue bulkheads 4 and 5 to
the jig.
Remove both keels from their sheets.
Sand as before.
Using CA, glue both keels together. Be sure that
the keels are aligned with each other.
Clamp while drying.
Содержание VBox 2013 Edition Deep Vee Sport Crackerbox
Страница 6: ...6...