![background image](http://html1.mh-extra.com/html/zippkits/vbox-2013-edition-deep-vee-sport-crackerbox/vbox-2013-edition-deep-vee-sport-crackerbox_building-instructions_3812149025.webp)
25
All transom hardware in place.
Engine sitting on scrap wood.
Tracing around rubber mounts.
Engine
mounting
Put a ¼ inch drill bit in the collet.
Use scraps of wood to angle the engine so that
the drill bit is pointing to the center of the boat,
and about 3 inches in front of bulkhead 4.
The engine should be mounted as far forward
as you can. Within ½ inch of the front of the ply
rails.
Mark the rear hole locations on the engine rails
as follows.
Once you are happy with the engine placement,
draw around as much of the rubber isolators as
much as you can. Use a sharp pencil.
Remove the engine and use a flat washer about
the size of the rubber isolators to draw a center
hole.
Drill this hole ¼ inch with a right angle drill.
Содержание VBox 2013 Edition Deep Vee Sport Crackerbox
Страница 6: ...6...