![background image](http://html1.mh-extra.com/html/zippkits/vbox-2013-edition-deep-vee-sport-crackerbox/vbox-2013-edition-deep-vee-sport-crackerbox_building-instructions_3812149033.webp)
33
Do this the same way you did the bottom.
Use 80 grit to finish it up. Be sure not to round
the edges.
Cut about 20 pieces of wide tape for the next
steps.
A shipping tape dispenser works very well for
this.
Mix about 1 ounce of 30 minute epoxy.
Using a stick or acid brush, coat the tops of the
bulkheads, chines and spines with epoxy.
Work quickly.
Start taping the deck down.
Align and tape the center of the deck at
bulkhead 3.
Then align and tape at the nose, then center of
the transom.
Start taping the sides.
Tape tightly.
Check all around to make sure that the deck is
tight against the top of the hull.
Continue adding tape until the entire deck is in
contact all the way around. Check the transom
from behind, and add tape if needed. Check
bulkhead 3 as well. When everything looks
good, add weights to the deck center area.
Allow to cure overnight.
After the deck sheeting is fully cured, use your
plane and 80 grit to sand flush.
Give the whole boat a good sanding with your
80 grit block.
Use wood filler to fill any gaps or gouges, and to
build up the nose, if necessary.
After the filler is dry, sand it with 80 grit, using
light pressure. At this point, you can round the
deck where it meets the sides.
Don’t round off any edges except for the top
deck. We need all other edges sharp to sheer
water.
Tape and weights.
Whatever it takes.
Hatch halves.
Содержание VBox 2013 Edition Deep Vee Sport Crackerbox
Страница 6: ...6...