![background image](http://html1.mh-extra.com/html/zippkits/vbox-2013-edition-deep-vee-sport-crackerbox/vbox-2013-edition-deep-vee-sport-crackerbox_building-instructions_3812149037.webp)
37
Measuring flex shaft.
Leave a gap at the rear for flex shaft “wind up”.
Remove the cable assembly and cut the cable
by the amount you just determined.
To cut the cable, use a motor tool with a cut off
disk, and file or grind the end smooth.
Put the cable back in and there should be a 1/4
inch gap between the strut and drive dog.
You must have this ¼ gap when running, as the
cable will “wrap up” and get shorter in use.
Finishing
Sand the entire hull with 80.
Fill any dings, dents, craters, valleys or chips
with wood filler.
When dry, sand again with 180. Check to make
sure that all imperfections are filled.
If not, fill and sand again.
Spend a little time getting this right, as it will
make your boat look so much better when done.
Blow off the hull with compressed air, or use a
vacuum to get the dust off.
Mix about 1 ounce of finishing resin, or 2
ounces of Klass Kote.
Use a credit card to spread out the resin on the
top and sides.
Sealing the outside.
Содержание VBox 2013 Edition Deep Vee Sport Crackerbox
Страница 6: ...6...