![background image](http://html1.mh-extra.com/html/zippkits/vbox-2013-edition-deep-vee-sport-crackerbox/vbox-2013-edition-deep-vee-sport-crackerbox_building-instructions_3812149035.webp)
35
Hatch screwed in place.
Seal the radio box, inside and out.
Stay close to the corner so that you drill thru
both the hatch and the corner bolt plate.
We measure ½ inch from each edge. Where the
lines intersect, drill.
Remove the hatch and drill the holes in the
hatch only with a ¼ inch drill bit.
Tap the hole in the bolt plate with a ¼-20 tap.
Wick some thin CA into the threaded holes and
hit each with a shot of accelerator. Wait a few
seconds.
Run the tap thru the threads again.
Put the hatch back in place and attach with the
supplied nylon screws.
Remove the hatch.
Apply epoxy resin sealer or Klass Kote to the
hatch and set on waxed paper to cure.
Apply a second coat of sealer to the hatch.
Next, we will mount everything we need, to
make this boat go!
Radio Box Top
Glue the radio box top on.
This is the 1/8 inch Birch top without lid.
Using 80 grit, sand the overhang on the top so
that it’s flush with the sides.
Sand the top with 180 or 220 grit paper on a
block.
Go get the lid and the 1/8 ply radio box top that
you moved earlier.
Glue the 1/8 ply top to the radio box.
It has a slightly larger hole for the lid, so try to
center it so that the “lip” is even all around.
Make sure that you don’t get any glue in the
“lip”, as it will interfere with the way the lid seats.
Содержание VBox 2013 Edition Deep Vee Sport Crackerbox
Страница 6: ...6...