![background image](http://html1.mh-extra.com/html/zippkits/vbox-2013-edition-deep-vee-sport-crackerbox/vbox-2013-edition-deep-vee-sport-crackerbox_building-instructions_3812149036.webp)
36
Drive dog and prop in place.
Shaft filed for drive dog set screw.
Sand the entire box with 180.
You can seal the inside, top and all four sides of
the outside in one session.
Also seal the servo mounts.
Allow to cure overnight.
When cured, seal with a second coat.
Flex cable prep
Get the flex cable, drive dog, prop and prop nut.
Put the drive dog on the stub shaft, then the
prop.
Engage the drive dog into the prop, and slide
this assembly back until the prop covers about
half of the threads on the stub shaft. Tighten the
drive dog set screw.
Mark the stub shaft at the front of the drive dog.
Remove the dog and prop.
Measure 3/16 inch back from your line, and file
a flat spot, about 1/8 inch wide and 1/16inch
deep.
This is for the set screw. File off any burrs, and
put the drive dog back on, tightening the set
screw into the flat.
Loosen the collet and slide your assembled flex
shaft in until it bottoms out in the collet. Do this
several times, and make sure it goes in all the
way (at least about ¾ of an inch).
Tighten the collet slightly with two wrenches.
Measure the distance from the back of the strut
to the front of the drive dog. Subtract 1/4 inch
from your measurement.
We want the shaft ¼ inch too long.
Содержание VBox 2013 Edition Deep Vee Sport Crackerbox
Страница 6: ...6...