Twinspeedy / Sailspeedy
Sailspeedy / Twinspeedy instructions
1
Building instructions
Twinspeedy
Order No. 1319/01
Sailspeedy
Order No. 1319/00
“aero-naut” Modellbau
Stuttgarterstr. 18-22
D-72766 Reutlingen
Germany
http://www.aero-naut.de
This model is of very simple construction, and can be built even by modellers with little prior
experience. All the parts contained in the kit are numbered, and the numbers are included in the text,
the stage photos and the parts list. It is important to complete the model in the sequence described in
these instructions, and to allow all glued joints to harden completely at the end of each stage before
resuming construction. We at “aero-naut” are unable to monitor the methods you use to build the
model, and for this reason “aero-naut” accepts no liability for damage or injury caused during
construction or operation of this model.
Flying this model successfully requires a basic knowledge of model flight. If you are a beginner please
ask an experienced model pilot to help you during the initial stages of learning to fly.
Use 5-minute epoxy for all joints.
Extra items required to complete the model
1
RC (radio control) system with V-tail mixer
4
9 g servos
1
Receiver battery
1
Clear adhesive tape, 10 - 20 mm wide
1
5-minute epoxy (two-pack resin adhesive)
1
Speed controller (for Twinspeedy only)
2
Race 400 6V motors, Order No. 7000/42, or Speed 400 6V (for Twinspeedy only)
2
Propellers (for Twinspeedy only), Order No. 7249/08
1
6-cell sub-C flight battery or 7-cell 4/5 sub-C flight battery (for Twinspeedy only)
Translation for following pictures:
6 Servokabel
Servo lead
9
Schnitt
Cut
14
Kohlefaserrohr
Carbon fibre tube
Servoschacht
Servo well
Tragflaeche
Wing
Schnitt
Cut
Querruder
Aileron
Schlitz
Slot
Schnitt
Cut
18
Spinner cap
