Zippkits VBox 2013 Edition Deep Vee Sport Crackerbox, Инструкция по сборке

Страница: 26 / 44

26
Mount the engine to the rails.
Mark the location where the drill bit points to the
bottom.
Remove the engine.
Put the 5/16 brass shaft tube in place and mark
the location where the bit pointed to.
Be sure to leave at least ½ inch sticking out of
the transom.
Remove the tube.
Anneal the brass tube around your mark. Do
this by heating the tube with a propane torch
until if changes color (a few seconds) and allow
to cool.
When cool, carefully and slowly bend the tube
on your mark to about 40 degrees, or about the
same angle as the engine.
Put the drill bit into the brass tube as you slide
the engine in place.
You can bend the tube as you put the engine in.
You may need to cut some of the brass tube at
the engine end. You want to end up with about
½ inch gap between the engine collet and brass
tube.
Work the engine in, adjusting the bend in the
brass as you go.
Using washer to mark center holes.
Engine mounted to rails.
Shaft tube in place over drill bit.