9-10
IM AQ1200-01EN
9.4 Selecting and Saving Core and Tape Numbers
Procedure
Data Save Screen
1.
Using the
rotary knob
and
ENTER
, select
LS_OPM
(the power meter light source).
2.
Press the
Save Data
soft key to display the following screen.
On the detailed setup screen on the next page, you can set the starting core number, tape number type,
and number of fibers.
Core no.
Check mark indicating that the data has been saved
Skipped core numbers are dimmed.
The core number that is set as the save destination is highlighted.
Set the list to show (Core List, List).
Data (measurement conditions and measured values)
The data set in section 9.2 is displayed.
Save area
Save area
When “Display” is set to “List”
Core no.
When “Display” is set to “Core List”
You can save up to three sets of
data in the save area of the
specified core.
Use the rotary knob and the
arrow keys to select a core
number.
Use the rotary knob and the arrow keys to
select a core number.
Delete data (see the Delete Data screen in
the next page).
You can save up to three sets of data in the
save area of the specified core.
Saves the data
Specify skipping.
To cancel skipping, press this soft key again.
