3-14
IM AQ1200-01EN
3.8 Giving Notifications When Installations Are
Complete
Procedure
1.
Using the
rotary knob
and
ENTER
, select
OTDR
.
2.
Press
SETUP
, the
System Setup
soft key, and then the
OTDR
soft key to display the following
screen.
Configure the work completion notification.
Press ENTER to display the Work completion notice setting
dialog box.
(See the Work completion notice setting dialog box below.)
Work Completion Notice Setting Dialog Box
Configure the work completion notification.
Turns notifications on or off
Set how to display the real-time measurement
confirmation message
(No Check, Check only once, Check everytime).
Turns the alarm notification upon work completion
on or off
Turns the message display upon work completion
on or off
Explanation
Before you check whether the work is complete, move the cursor to the fiber end point after the optical
fiber has been installed (the extension work point or the work completion point) and turn on the work
completion confirmation notification. When the fiber end detection position (the event) during real-time
measurement is the same as the cursor position (CheckPoint), the AQ1200 gives a notification that the
installation is complete.
Work start
position
Distance
Level
Extension work point
(splice, connection, etc.)
CheckPoint
Completion notification
cursor position during
optical fiber extension
Work completion
point
CheckPoint
Work completion
notification cursor
position
50 km
100 km
(Event)