2-1
IM AQ1200-01EN
Common Operations
3
2
1
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
Index
App
2.1 Top Screen
When you turn the AQ1200 on and it starts, the top screen appears.
To use the various AQ1200 features, first select a feature from this top screen, and then configure the
feature or carry out the measurement that corresponds to the feature you have selected.
The following procedural explanations assume that you have already selected the corresponding
feature from the top screen.
1.
Turn the AQ1200 on to start it.
2.
Use the
rotary knob
to select the feature. An image that shows the selected feature is
displayed.
3.
Press
the center of the rotary knob
or
ENTER
to confirm your selection. The setup or
measurement operation menu for the selected feature is displayed.
In this manual, steps 2 and 3 given above are explained as shown below.
For example, to select the OTDR feature and confirm your selection:
Using the
rotary knob
and
ENTER
, select
OTDR
.
Displays an image that shows
the selected feature
Displays a term that represents the selected feature (OTDR, LS_OPM, Auto Loss Test, Multi-Core
Loss Test, IP Test, Fiber Inspection Probe, Fault Locator, Visible Light Source, or PON_OPM)
Rotary knob
ENTER key
The center of the
rotary knob
Displays an explanation of the selected feature
Top menu
Procedural Explanations of Features
For explanations of the procedures to perform after you have selected and confirmed a feature, see
the chapters or sections that are listed in the following table.
OTDR (optical pulse measurement)
Chapters 3 to 7
LS_OPM (power meter and light source)
Chapters 8 and 9
Auto loss test (auto loss test and loopback loss test)
Chapter 11
Multi-core loss test
Chapter 12
IP test
Chapter 15
Fiber inspection probe (fiber end face check)
Chapter 14
Fault locator
Chapter 13
Visible light source
Section 8.2
PON_OPM (PON power meter)
Chapter 10
Chapter 2
Common Operations