9-186
1596
45-1
C
D
RE-CHO-A1
11
FS10
0
4592
SPEED CTRL MODE
CANCEL ERROR(SV)
Software operation error
occurred
(1)Reset the alarm, and then try again.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance mode, and
then contact your YASKAWA representative about occurrence status (operating
procedure).
4595
CAN'T DO FIXED FORM
CUT MOTION
1
The setting for radius is incorrect.
(1) For a circle, it is incorrectly set
as: radius <= 0, or radius <
minimum radius value, or radius >
maximum radius value.
(2) For an ellipse, it is incorrectly
set as: radius <= 0 or radius <
minimum radius value/2, or radius
> (maximum radius/2 - width/2)
value.
Setting error
(1)Check the following settings.
·Setting of the radius data
2
The setting for width is incorrect.
(1) For a rectangle, it is incorrectly
set as: width < 1.0, width > sqrt
(maximum diameter2 - height2),
or width > maximum diameter.
(2) It is incorrectly set as: width <
0, width > maximum diameter -2 *
radius.
Setting error
(1)Check the following settings.
·Setting of the width data
3
The setting for height is incorrect.
(1) For a rectangle, it is incorrectly
set as: height > maximum
diameter, height < minimum
diameter/2, or height > sqrt
(maximum diameter
2
- width
2
).
Setting error
(1)Check the following settings.
·Setting of the height data
4
The setting for the corner radius is
incorrect.
(1) For a rectangle, it is incorrectly
set as: corner radius > width/2 or
corner radius > height/2.
Setting error
(1)Check the following settings.
·Setting of the corner radius
Alarm
Number
Alarm Name
Sub
Code
Meaning
Cause
Remedy
288 of 348
