Xo FLOW, Руководство по установке, Страница: 52 / 74

XO FLOW – Installation instructions
52
Figure 70 – Mains supply cable
Assemble the socket CC-152 (supplied in the installation kit AR-135) to line (L), neutral (N)
and earth
( ) from the mains power supply cable and connect Mains to the Mains switch
located on the rear of the unit base frame.
1. Strip 37 mm of the outer insulation of the Mains cable as illustrated in Figure 71.
2. Strip 8 mm of the inner insulation of the Mains cable as illustrated in Figure 71.
3. Terminate the conductors (solid conductors) by simply pushing them into the socket as
illustrated in Figure 72. Mains connector tool is not needed with solid conductors but can be
useful: WAGO 890-383.
4. Latch the wired connector into the base of the strain relief housing as illustrated in Figure 73.
5. Push down the strain relief clamp by hand as illustrated in Figure 74.
6. Latch the top of the strain relief housing as illustrated in Figure 75.
Figure 71 – strip the conductors