Xo FLOW, Руководство по установке, Страница: 18 / 74

XO FLOW – Installation instructions
18
Figure 17 – Adjusting the unit base, (1) adjustment nut and (2) bushing in the floor
5.2.5 Alignment of the unit base
1. With the special wrench (MG-416), adjust the brass adjustment bushing – (5) in Figure 18 – in
the supporting leg and allow for approximately 10 mm clearance between the supporting leg
and the floor surface.
2. Fit the screw and the washer – (9) and (10) in Figure 10 – in the hole through the adjustment
bushing – (5) in Figure 18 – do not tighten.
3. Turn the adjustment nuts – (1) – (4) in Figure 18 – into the unit base, allowing for
approximately 5 mm clearance all the way between the unit base and the floor surface, and
make sure that all four adjustment nuts are resting on the bushings in the floor. The nuts on
top of the long rods should be loose.
4. Place a spirit level on top of the bridge arm post in the longitudinal direction – (A) in Figure 18 –
see Figure 19.
5. Turn the adjustment nut – (2) in Figure 18 – until the post is plumb in the longitudinal direction
and then tighten the nut on top of the long rod.
6. Turn the spirit level to adjust the unit stand in the crosswise direction – (B) in Figure 18 – see
Figure 20.