Xerox Phaser 840, Руководство по обслуживанию, Страница: 194 / 287

6 - 178 Phaser 840/850/860/8200 Color Printer - Service Manual
Inspection
Rollers: Replace the rollers when you see any of the following defects:
■
Flat spots
■
Out of roundness
■
Cracked rubber
■
Loss of traction (tackiness) causing pick or feed failures
Gears: Replace gears that show any signs of wear or breakage. Look for these problems:
■
Thinned gear teeth.
■
Bent or missing gear teeth; check especially where a metal gear drives a plastic
gear.
■
Fractured or cracked gears (Oil or incorrect grease on a plastic gear can cause
the gear to crack.)
Belts: Inspect the belts for wear. There are eight rubber belts in the printer:
■
A belt from the process motor to the compound gear
■
Two belts from the y-axis motor drive
■
A belt from the lower paper-feed roller to the upper paper-feed roller
■
Two belts on the cap/wipe/purge drive
■
An exit-roller drive belt
■
A small belt for driving the cap/wipe purge assembly from the cap/wipe/purge
clutch
Look for these problems:
■
Loose rubber particles below the belts indicate a worn belt
■
Missing teeth in the belts
■
Cracking or moderate fraying; a small amount of fraying is inevitable, so look
for other signs of wear before replacing the belt
Clutches: There are four clutches: the paper-pick roller clutch, the upper-feed-roller
clutch, the maintenance drawer cam clutch and the cap/wipe/purge clutch. Symptoms of a
malfunctioning clutch are the printer not picking paper from the tray or other paper jams.
Also the cap/wipe/purge system could fail. In such cases, replace the clutch. Intermittent
jams are often caused by failing clutches.