WinGD X82-B, Руководство по обслуживанию

Страница: 609 / 841

PROCEDURE
1 Make sure that all items are clean and do not have damage.
2 Apply oil to the top bearing shell half , the bottom bearing shell half and the camshaft .
3 Put all bottom bearing shells into the casing in their correct positions. Refer to the marks
you made before.
4 Put the camshaft (007, Figure 10-32 ) and gear wheel (001) in position on the two
support (004, 005).
5 Carefully move the camshaft (007) and the gear wheel (001) into the casing. Make sure
that the bearing shells stay in position and do not fall.
6 Make sure that the camshaft does not move.
7 Put the screw-jack (002) in position.
8 Turn the screw-jack (002) to lift the camshaft between 0.05 mm and 0.15 mm.
Fig 10-32 Camshaft
9 Attach the assembly template (005, Figure 10-33 ) on the bottom elastic bolt (003) with
the round nut (003).
10 Tighten with your hand the round nut (003).
11 Put the top bearing shell (006) in position on the camshaft (007).
12 Put the assembly template (002) in position on the bottom half of the top bearing shell
(006). Use the assembly template to help you get the bearing shell in the center.
13 Use the assembly template (002) to move the bearing shell (006) 90° up.
14 Make sure that the semicircular slots of the top and bottom bearing shells are in a
horizontal position.
15 Remove the assembly templates (002, 005).
16 Remove the holders (004 and 005, Figure 10-32 ).
X82-B
AA00-5581-01AAA-720A-A
Maintenance Manual Supply unit camshaft and bearing shell - install
Winterthur Gas & Diesel Ltd.
- 609 - Issue 001 2020-10