WhitakerAudio J C Whitaker 20 W Stereo Audio Amplifier, Руководство пользователя

Страница: 124 / 194

124
WhitakerAudio
– Twist the two black wires together. Route to the rear of the chassis using the front cable
clamp along the left channel PWB. Attach quick-disconnect terminals to the ends of each
wire.
– Prepare a 26-inch long #22 blue wire. Attach one end of the wire to the center terminal of
the front panel Auto-Off switch, SW202 . Solder.
– Prepare a 26-inch long #22 blue wire. Attach one end of the wire the remaining terminal
on the front panel Auto-Off switch, SW202 . Solder.
– Twist the two blue wires together. Route to the rear of the chassis using the available cable
clamps along the left channel PWB.
– Find the 4-terminal Molex connector and pins. Attach a pin to each blue wire. Insert a
wire/pin into position #3. Insert the other wire/pin into position #4 on the connector.
– Prepare two 26-inch blue #22 twisted wires. Attach a Molex pin to each wire. Insert a
wire/pin into position #1 of the 4-terminal Molex connector. Insert the other wire/pin into
position #2 on the connector. Route the free end of the twisted pair to the power
management expansion PWB using the available rear cable clamp.
– Prepare a 25-inch long #22 violet wire. Attach a quick-disconnect terminal to each end of
the wire. Connect to the V+HV post on the power management PWB. Route to the side of
the chassis using the cable clamp adjacent to the left channel PWB.The free end will be
connected later during installation of the preamplifier power supply PWB.
– Prepare a 23-inch long #22 violet wire. Attach a quick-disconnect terminal to each end of
the wire. Connect to the V+ post on the power management PWB. Route the free end
toward the power management expansion PWB using the available cable clamp.The free
end will be connected later
– Prepare a 23-inch long #22 black wire. Attach a quick-disconnect terminal to each end of
the wire. Connect to the GND post on the power management PWB. Route the free end
toward the power management expansion PWB using the available cable clamp.The free
end will be connected later.