WhitakerAudio J C Whitaker 20 W Stereo Audio Amplifier, Руководство пользователя

Страница: 121 / 194

121
20 W Stereo Audio Amplifier
– Attach a quick-disconnect terminal to the free end of the 5-inch #18 black wire. Attach to
the GND post on the left channel speaker PWB.
– Prepare a 10-inch long #22 yellow wire. Attach a quick-disconnect terminal to one end of
the wire.
– Find the #22 yellow wire from the front panel Speaker On/Off switch. Combine the wire
with the #22 yellow wire in the previous step and attach a quick-disconnect terminal (two
wires crimped together). Connect to the RYL post on the right channel speaker PWB.
Connect the other terminal to the RYL post on the left channel speaker PWB.
5.6.11.4 Headphone Jacks
On the headphone jacks, there are three terminals—commonly known as tip , ring , and sleeve .
Identify each of the terminals. This can be done by a visual inspection of the socket, or with an
ohmmeter. Note that:
• The sleeve is the common (ground) connection.
• The ring is the right channel connection.
• The tip is the left channel connection.
– Prepare a 19-inch long 2-conductor shielded cable. Remove 4-inches of insulation from
one end, and 2-inches of insulation from the other end. Attach a quick-disconnect terminal
to each of the wires (black, white, and shield drain) on the 4-inch side. Attach the
connectors as follows:
• White to the HEAD1 terminal on the right channel speaker PWB.
• Black to the HEAD1 terminal on the left channel speaker PWB.
• Shield to the GND terminal on the left channel speaker PWB.
– Route the 2-conductor shielded cable to the front panel and the1/4-inch headphone jack
(J1). Make the following connections:
• White to the ring terminal on J1. Solder.
• Black to the tip terminal on J1. Solder.
• Shield to the sleeve terminal on J1. Solder.