WhitakerAudio J C Whitaker 20 W Stereo Audio Amplifier, Руководство пользователя

Страница: 102 / 194

102
WhitakerAudio
tubing on each end of the sleeving. Process with the heat gun. Be careful to focus the heat
on the heat-shrink tubing, not the sleeving.
– Cut one 3-inch piece of small expandable sleeving. Cut two pieces of small heat-shrink
tubing, each about 3/4-inch long.
– Feed the 3-inch piece of small-sized sleeving onto the leads of choke L51. Include the
black ground wire from the choke case. Position one end of the sleeving near the base of
the device (where the leads enter the chassis). Stretch the sleeving to its full length. Place
one piece of heat-shrink tubing on each end of the sleeving. Process with the heat gun. Be
careful to focus the heat on the heat-shrink tubing, not the sleeving.
– Cut one 3/4-inch piece of large heat-shrink tubing.
– Feed the large-sized heat-shrink tubing onto the front set of leads of power supply
transformer T51. Position near the base of the transformer (where the leads enter the
chassis). Process with the heat gun. Be careful to focus the heat on the heat-shrink tubing,
not the leads. This cable bundle will connect to the rectifier PWB.
– Cut one 3/4-inch piece of large heat-shrink tubing.
– Feed the large-sized heat-shrink tubing onto the rear set of leads of power supply
transformer T51. Position near the base of the transformer (where the leads enter the
chassis). Process with the heat gun. Be careful to focus the heat on the heat-shrink tubing,
not the leads. This cable bundle will connect to the right channel PWB.
– Cut one 5-inch piece of small expandable sleeving. Cut two pieces of small heat-shrink
tubing, each about 3/4-inch long.
– Feed the 5-inch piece of small-sized sleeving onto the primary (black) windings from
transformer T301 (the preamplifier power supply filament transformer). Place one piece
of heat-shrink tubing on each end of the sleeving. Process with the heat gun. Be careful to
focus the heat on the heat-shrink tubing, not the sleeving.
– Cut one 5-inch piece of small expandable sleeving. Cut two pieces of small heat-shrink
tubing, each about 3/4-inch long.