
1•3 SVA Cover Set
FITTING OF SVA COVER SET
1
Front Bolt Covers
1
Locate from your parts (six M6 Hex
Head Bolt Covers[C])
2
Position the four M6 covers [C] on the
anti roll bar clevises nuts and bolts, if
your car is running anti roll bars. The
covers are fixed by simply pushing them
on (Fig
1.1
).
1.1
3
Position one M6 cover [C] over the M6
bolt head on the forward mounting of
the cycle wing bracket (Fig
1.2
).
1.2
4
Position one M8 bolt cover [O] over the
M8 bolt securing the steering arm to the
upright. The steering arm also requires a
cover [C] on the M6 bolt securing the
steering arm to the upright (Fig 1.3).
1.3
5
Locate from your parts the track rod
cover [B]
NOTE:
A cover is required to protect the ball joint
locking nut. If you have not already fitted
the steering arm cover it will be necessary to
remove the track rod end to fit the cover.
6
Remove the track rod end if necessary,
cut the closed end off the sleeve. (Fig
1.4)
1.4
7
Slide the sleeve over the track control
arm and refit the track rod end (Fig 1.5).
1.5
8
Slide the cover over to protect the
locking nut.
9
Locate from your parts one M10 bolt
cover [O]. Fit the cover over the nut
securing the track rod ball joint to the
steering arm (Fig 1.6).
1.6
10
Locate from your parts two M10 bolt
covers [O]. Position the covers over the
two bolts securing the lower ball joint to
the wishbone (Fig 1.7).
1.7
NOTE:
If you have anti roll bars fitted the front
edge of the tube needs covering this is done
by bonding a bolt in place with silicone then
fitting a bolt cover.
11
Locate a spear M8 bolt from your parts
applie a liberal amount of silicon sealant
to the end and insert into the open
section of the anti roll bar (Fig 1.8).
1.8
12
Carefully position an M8 bolt cover [N]
over the bolt head.
13
Locate one M18 bolt cover [E] from your
parts.
14
Cut the domed end off the bolt cover
leaving just the hex section. Also cut a
slit down the center so that the cover
can be spread apart.
15
Fit the M18 cover [E] over the upper
wishbone ball joint lock nut. Secure with
a cable tie (Fig 1.9).
Содержание AeroRace 2008
