Westfield AeroRace 2008, Руководство по сборке

Страница: 28 / 99

Wiring Loom 3•9
10
Locate the brake light switch wires
(Green x2) and run them down the
driver’s side bulkhead to the brake
pressure switch fitted in chapter two.
11 Fit the large blue fuse on the driver’s
side of the tunnel just above the
bulkhead (Fig 6.7).
6.7
12
Locate the ‘coil’ plug on the loom and
temporally position it near the blue fuse
it does not need to be connected or
secured until the engine is fitted (Fig
6.8).
6.8
13 Locate and separate the fuel injection
signal wires from the loom place them
over to the driver’s side not securing
until the engine is fitted (Fig 6.9).
6.9
14 Locate the earthing eyelet and mount it
on to the stud welded to the chassis
brace in front of the passenger side
bulkhead (Fig 6.10).
15
Locate the Master switch wires on the
main chassis harness (green x2 and
Black). There position should be on top
of the scuttle panel. If not run them up
through one of the grommets.
6.10
16
Run the three master switch wires to
the driver’s side of the scuttle (GRP
body part). Along the scuttle panel. (see
wire loom layout at the beginning of the
chapter).Secure with saddle clamps and
cable ties.
NOTE:
Any earthing straps that do not reach a
specific earthing point should be fixed to a
convenient point on the chassis with a cap
screw and rivsert into the chassis.
7 Fitting -Dash &
Instruments
NOTE:
Proceed to step 8 for digital dash fitment.
1
Locate the dashboard from your parts
along with the clock set or digital dash
depending on what you have chosen
(Fig 7.1).
7.1
2 Mount the gauges in to the dash, the
smaller ones have a screw on cap, the
large one a clamping bracket (Fig 7.2).
7.2
3
Fit the ON, OFF and FOG switches to
the dash, and warning lights.
4
Locate the dash harness from your
parts and connect up to the back of
A
B
C
D
A. Master Switch
B. Battery
C. Starter Motor
D. Chassis Earth