Westfield AeroRace 2008, Руководство по сборке

Страница: 49 / 99

7•3 Fuel Tank & Supply System
FITTING FUEL SYSTEM
1 Fitting – Tank Frame
NOTE:
If you are fitting anti roll bars see chapter 15
before fitting the fuel tank frame.
1
Locate the frame [B] from your parts
and note its location behind the rear
bulkhead as shown in the diagram on
the previous page (Fig 1.1).
1.1
2 Remove the nyloc nut securing the
7/16
th
bolt for the upper wishbone.
3 Knock the bolts partially out so the cage
can be slid into position.
4
Knock the bolts back into position and
secure with nyloc nuts and a washer.
2 Fitting – H/P Pump & Filter
1
Locate the alluminium bracket [L] for
fitting the fuel pump.
2 Mark two points 10mm from the edges
across the center line of the flat of the
bracket (Fig 2.1).
2.1
3 Drill two 5mm holes at the points
marked.
4
Locate the fuel pump [E] and filter [F]
from your parts.
5 Wrap both the filter and the pump with
foam tube.
6 Place the bracket [L] over the pump.
7
Place the bracket [M] over the fuel
filter.
NOTE:
The filter is mounted to the tank mounting
frame [B]. And the H/P (high pressure) pump
[E] is mounted on the upper chassis rail.
8 Mark two points 82mm apart on the
underside of the tank mounting frame
80mm from far left of the mounting
frame (Fig 2.2 & 2.3).
2.2
9
Drill two 7mm holes at the points
marked
10
Fit two M5 rivserts into the holes drilled.
11
Secure the filter to the fuel tank
mounting frame with M5x16mm dome
headed setscrews.
2.3
12 Position the H/P pump on the chassis
cross member 120mm from the upper
left hand wishbone mount (Fig 2.4).
13 Use the holes in the alluminium bracket
as a guide to mark the position of the
holes.
14 Drill two 7mm holes at the points
marked.
15 Fit two M5 rivserts into the holes.
16 Secure the H/P pump to the rivserts
with
M5x16mm dome headed
setscrews.
Fuel Tank Mounting Frame [B]