Westfield AeroRace 2008, Руководство по сборке

Страница: 14 / 99

2•3 Pedal Area and Pipes
FITTING OF PEDALS AND PIPES
1 Fitting – Clutch Pedal
1
Locate the clutch cable [N] and pedal [E]
from your parts. Trial fit the cable in its
mounting on the driver’s bulkhead. The
end with the rubber ‘donut’ goes
against the bulkhead.
NOTE
The aluminium bulkhead panel may require
enlarging slightly to allow fitment.
Be careful not to enlarge the hole in the
chassis as this may damage the chassis and
prevent correct function of the clutch.
2 Place the clutch cable through the
bulkhead hole and into the pedal end.
3 Secure the cable to the pedal with a
clevis pin [I] (Fig 1.1).
1.1
4
Place a 6mm plain washer over the
clevis pin.
1.2
5
Locate the 20mm split pin [J] into the
clevis pin ensuring the washer is
between the pedal and the split pin.
6 Apply copper grease to the 31mm steel
bush [F].
7
Insert the bush into the pedal (Fig 1.2).
8
Locate 1 M8 x 70mm stud and screw an
M8 nyloc nut on to the end leaving
approximately 5 clear threads. Slide a
washer on to the stud pushing it up to
the flat side of the nut.
9
Offer up the pedal to the uppermost
hole on the clutch pedal bracket and
insert the stud.
10 Place another 8mm steel washer on the
stud.
11
Screw on 1 M8 nyloc nut, do not over
tighten, the clutch pedal should move
freely (Fig 1.3).
1.3
12
Fit the clutch pedal stop M8x65mm set
screw and rubber foot grip (Fig 1.4).
1.4
2 Fitting – Brake Pedal
1 Feed the two master cylinders [B]
through the bulkhead and attach using
two M8x30mm set screws per cylinder
(Fig 2.1). An 8mm steel washer is
required on each end of the bolt. Secure
using M8 nyloc nuts.
2.1