Westfield AeroRace 2008, Руководство по сборке

Страница: 18 / 99

Pedal Area and Pipes 2•7
6.3
4
From the pressure switch union route
the pipe to the rear brake union.
Through the tunnel (Fig 6.4).
NOTE:
Fix the pipe through the tunnel using P-clips
not push in clips.
6.4
5
Place P-clips over the brake pipe to be
routed and drill the chassis with a
4.1mm drill bit in the desired position.
6 Position a 4.1mm rivet in to the hole
through the P-clip.
7
Pull the rivet up with a rivet gun to
finally secure the pipe.
8
The left and right rear brake pipes run
down the upper surface of the top
chassis rails (Fig 6.5).
6.5
9 Use ‘Push in clips’ to secure placing
them at 150mm apart.
6.6
10
The final clip should be mounted 35mm
away from the upper wishbone mounts
on the top face of the chassis rail (Fig
6.6).
7 Fitting – Fuel Pipe
NOTE:
The fuel pipe used measures 8mm diameter.
They are routed through the tunnel with the
rear brake line. Two hard lines required,
providing a return feed and return.
The pipes are held in place using the 8mm P-
clips. Remember that the P-clips can only be
fitted when the fuel line is in the correct
position.
To bend the fuel pipes a mini pipe bender
will be required (see below).
1 Get one of the two fuel pipes and put a
mark 100mm from one end. This is the
lower of the pipes.
2
Bend the pipe 33°, this bend is
considered the vertical plane (Fig 7.1).
3
Create a mark at 355mm and bend at
57° in the vertical plane.
4 Create a mark 470mm from the
previous one and bend at 8° towards
you in the Horizontal plane.
7.1