
Engine & Associated Systems 11•9
10.3
8
Locate a length of 25mm O/D flexible
fuel hose and a length of 20mm O/D
flexible fuel hose.
9
Push the 25mm O/D fuel hose onto the
larger tube on top of the catch tank fit a
jubilee clip over the hose and tighten.
10
Run the hose over to the breather pipe
on the rocker cover cutting to the
required length (Fig 10.4).
10.4
11
Place a jubilee clip over the hose before
attaching it to the breather pipe.
12
Locate the 20mm O/D fuel hose, push
the hose on to one of the smaller pipes
exiting the catch tank. Fit a jubilee clip
over the pipe and tighten.
13
Route the hose round the coil to the
other side of the engine and connect the
hose to the crank case emission control
valve located at the rear near side of the
engine. Cut to length as required (Fig
10.5).
10.5
14
Push the remainder of the 20mm O/D
fuel hose on to the remaining pipe
exiting the catch tank. Fit a jubilee clip
and tighten.
15
Route the hose to the vacuum union on
the air filter back plate (Fig 10.6).
10.6
11
Fitting – Fuel Hose
1
The Webcon throttle bodies come
complete with fuel hose attached
already. The hoses need to be attached
to the hard lines exiting the tunnel.
NOTE
As set up in chapter 7 the lower of the two
fuel lines is the feed to the engine.
2
Locate the hose that is attached to the
fuel regulator, route it neatly under the
throttle bodies to the hard lines (Fig
11.1).
3
Offer the hose up to the return line and
cut to length (Fig 11.2).
11.1
11.2
4
Secure the hose with a jubilee clip.
5
Locate the feed hose on the throttle
body, route it over to the hard feed line
(Fig 11.3).
11.3
6
Offer the hose up to the feed hard line
and cut to length. Secure with a jubilee
clip.
12
Fitting- Exhaust
NOTE:
The Exhaust should not be fitted until the
body has been fitted as it needs to exit
through the side panel.
1
Place the manifold [P] on to the exhaust
ports by feeding it through the body
work on the nearside of the car.
2
Bolt the manifold in place with the bolts
supplied with the engine (Fig 12.1).
12.1
3
Drill a 5mm pilot hole for the exhaust
mounting bracket from inside the
passenger compartment. Through the
M10 bush (Fig 12.2).
NOTE:
Make sure you drill through the correct
bush, NOT one of the 7/16 seatbelt bushes.
It is the third bush from the rear bulkhead.
Содержание AeroRace 2008
