Westfield AeroRace 2008, Руководство по сборке

Страница: 26 / 99

Wiring Loom 3•7
2.3
3 Fit two saddles to the passenger side
bulkhead (Fig 2.4).
2.4
4 Fit two saddles across the top of the
passenger side bulkhead and two down
the right hand side of the nearside
bulkhead (Fig 2.5).
2.5
3 Positioning -Rear Loom
saddles.
3.1
1
Position the 16 saddle clamps required
on the rear drivers side section
according to the diagram (Fig 3.1).
4 Fitting -Fuse Box
NOTE:
As mentioned at the beginning of the
chapter, make sure that all the fuse box
conections have been noted to their related
wires.
1 Disconnect the fuse box from the loom
and pass the connectors through from
the underside of the scuttle panel
pushing the grommet in to the panel
(Fig 4.1).
4.1
2
Reconnect the fuse box connecting the
spade connectors back to their original
locations.
3 Position the fuse box next to the
grommet, ensure the wires are not
stretched.
4
Using the fuse box as a guide mark the
position of the holes on to the scuttle
panel.
5 Drill two 7mm holes in the position
marked.
6 Secure two M5 rivserts into the scuttle
panel (Fig 4.2).
4.2
7
Locate two M5x20mm dome headed
screws from your parts along with two
spacers M5 IDx10mm long.
8
Push the screws through the fuse box
holes, fit the spacer and secure to the
rivserts (Fig 4.3).
4.3
5 Fitting -Rear Loom
NOTE:
With the fuse box in place the loom can be
orientated in its correct position, use the
wiring diagram as a guide to locate relevant
plug position e.g. Headlamp rear lamp etc.
The longest section of the loom is the rear
part and this should be routed along the
tunnel.
1 Run the long section of the loom
through the tunnel, fixing with cable ties
to the saddles fitted in section 1 (Fig5.1).
5.1
2 As the loom exits the tunnel it bends
round to the drivers side of the chassis
towards the saddle clamps fitted earlier.
Attach the loom with cable ties as used
in the tunnel (Fig 5.2).
5.2
3
4
5