Westfield AeroRace 2008, Руководство по сборке

Страница: 38 / 99

Revision 37
Chapter 5
Differential and Rear Brakes
Contents
INTRODUCTION .............................................................. 1
Tools Required ................................................................ 1
Standard Parts ................................................................ 1
Parts Required ................................................................ 2
1 Fitting - Differential .............................................. 3
2 Fitting – Drive Shafts ........................................... 3
3 Fitting – Disk & Calliper. ....................................... 4
4 Fitting – Rollcage Supports ................................... 4
INTRODUCTION
Differential and Drive Shafts
The differential unit is fitted to the chassis via four metalastic bushes that are pre-fitted to the chassis. A stabilizing bracket is also used to
secure the differential housing.
The differential casing has been modified to allow it to fit into the chassis. This is worth noting if for any reason you need to source another
differential or if you supply your own.
Rear Braking System
The rear calipers used are a twin pot type and are not equipped with a hand brake mechanism.
Rollcage Support Side Impact .
The full rollcage fitted requires 18 mounting points. Four of these points do not intersect the chassis so in order to fit the cage, two additional
support bars are required. The nature of the fitment means that they must be fitted before the body work is fitted. Hence the reason for fitting
them in this section not the rollcage section
.
Tools Required
A. 5/8 Spanner x2
B. 13mm Spanner x2
C. 17mm Spanner x2
D. 19mm Spanner x2
E. 5/8 Socket x2
F. 13mm Socket x2
G. 17mm Socket x2
H. 19mm Socket x2
I. Torque Wrench
J. Ratchet
K. Thread-Lock
L. Copper Grease
M. 10mm Allen Key Driver
N. 8mm Allen Key Driver
O. 6mm Allen Key Driver
Standard Parts
A. M12 x 65 Bolt x2
B. M12 x 300 Stud x1
C. M10 x 25 Set Screw x2
D. M10 x 45 Cap Screw x4
E. M10 x 40 Cap Screw x4
F. M8 x 50 Cap Screw x24
G. 7/16” x 2 ½” x1
H. M12 Nyloc Nut x2
I. M10 Nyloc Nut x4
J. 7/16” Nyloc Nut x1
K. M12 Washer x10
L. M12 Spring Washer x4
M. M10 Spring Washer x4