Parameterization
5-2 | SRW 01
5
NOTE!
Make sure the purchased control unit (UC) model has those functionalities. Check the identification
label or the product warning label for the model of the purchased Control Unit (UC).
NOTE!
Protections by phase sequence, voltage unbalance, phase loss (voltage), overvoltage, undervoltage,
overpower, underpower, power over factor and power under factor, only available when the Current/
Voltage Measurement Unit (UMCT) is used.
NOTE!
There are parameters that can be changed only with the motor deenergized. In an attempt to change
those parameters with the motor on, the message “stop” will flash during 3 seconds on the HMI and
the modification will not be accepted.
5.1 LOCAL/REMOTO
This parameter defines the origin of the command that will select the SRW 01 working mode (Local/Remote) and
its initial state.
P220 – Local/Remote Selection
Adjustable
Range:
0 = Always Local
1 = Always Remote
2 = HMI key (LOC)
3 = HMI key (REM)
4 = Digital Input I13
5 = Digital Input I14
6 = Fieldbus (LOC)
7 = Fieldbus (REM)
8 = USB/Ladder
9 = Digital Input I15
10 = Digital Input I16
Factory
Setting:
2
Proprieties:
Sys, rw
Description:
It defines the origin of the command for the Local/Remote operation selection.
If P220 = 4, 5, 9 or 10, the Local/Remote selection is done by the digital inputs, 0 = Local, 1 = Remote.
P220 = 8 USB/Ladder – The Local/Remote selection is done by the monitoring dialog box “control/signals”, via
USB, or by the Ladder user program, via the system bit marker SX3006 (refer to the WLP manual).
Example: P220 = 2 – the HMI
key does the selection and the SRW initiates in Local mode.
5.2 LOCAL/REMOTE COMMAND
If the Local mode is selected, the origin of the local commands must be defined at the parameter P229.
P229 – Local Command Selection
Adjustable
Range:
0 = Ix
1 = HMI
2 = USB/Ladder
Factory
Setting:
0
Proprieties:
Sys, rw
Содержание SRW 01
