WEG SRW 01, Руководство пользователя

Страница: 70 / 148

Parameterization
5-24 | SRW 01
5
NOTE!
In the example above, the Check Back signal was configured for digital input, P208 = 1. The factory
setting is Check Back by motor current, P208 = 0. If P208 = 0, then the digital input I14 becomes free
for the user.
NOTE!
In the Pole Changing Starter mode the parameter P401 must be programmed with the low speed
nominal current and P402 must be programmed with the high speed nominal current.
NOTE!
The motor speed can be changed with the motor switched on, after the time defined in P212 has
elapsed.
5.4.8.1 Connection Diagram – Pole Changing Starter
The connection scheme on Figure 5.16 on page 5-24 shows an example of the use of the Control Unit (UC) on the
Two Winding Starting operation mode with drive through digital inputs (P229 or P232 = 0) at 24 Vdc using three
wires (pushbuttons) control logic (P230 = 1).
A2
A1 IC I16 I15 I14 I13 I12
I11
K1 K2
S1 S2 K1 K2 S0
M
3 ~
K2 K1
1 1
2 2
3 3
4 4
5 5
6 6
Q1
Q1
Q2
C1 C3 C4 01 03 04 02
R/L1
R/L1
S/L2
T/L3
N
110...240 VAC/VDC 50/60Hz
SRW01-UMC
L1
T1
L2
T2
L3
T3
SRW01-UC
SRW01-CB
V2 V1
V2 V1
W2 W1
Figure 5.16: Connection scheme for the Two Windings Starting operation mode using digital inputs at 24 Vdc and driven by pushbuttons
(P230 = 1)
The modifications of the scheme for drive through the digital inputs (P229 or P232 = 0) at 24 Vdc, and at 110 Vca, using
two wires (switch) control logic (P230 = 0) is shown on
Figure 5.17 on page 5-24 .
Q1
R/L1
N
A1 IC I16 I15 I14 I13 I12 I11
K1 K2
S0
110...240 VAC/VDC 50/60 Hz
Figure 5.17: Detail modification for drive using digital inputs at 24 Vdc and switch drive (P230 = 0)