Additional Modes
152
Iridium Manual
The Pad Trigger Mode
Tap on the
Mode
button and select
Pad Trigger
to switch
to the corresponding display page or press the
Trigger
button left of the pads.
In this mode the 4x4 pads will be sequentially run through
based on the direction given by the
Algorithm
parameter.
This pitches of each pad and therefore of the sequenced
steps will be taken from either the
Notes
,
Scale
or
Chords
pitch configurations of the pads. Press the respective but-
ton for setting up these pitches.
If no pad is latched all pads will be used to sequence the
notes. For rhythmic variation you can use the parameters
Rhythm Pattern
,
Swing
and
Rel Gate
.
You could also press the
Latch
button and then select a set
of steps by pressing the corresponding pads. These will
then lit white and only these will be used for playback, i.e.
when the algorithm is wandering through the pads only
the latched ones will play. For the other ones a rest will be
inserted. If you like to get back using all pads in playback,
then simply press
Latch
to un-latch everything.
XY Pad Tab
This page provides a X-Y pad, a two-dimensional controller
based on two selected modulation parameters.
First you need to define the X and Y controller within the
Modulation Matrix
. You can, for example, easily set up a
modulation for Cutoff (Pad X) and Resonance (Pad Y).
