26
Method 2:
Under monitoring mode interface, press
key, switch to next monitoring parameter item d-xx, press
key to
move flicker bit to ones digit of the monitoring code, then adjust
key or
key until the monitoring code displays
d-05, then operate according to step 2 and step 3 of method 1.
Example 3: check fault monitoring parameter in fault status
Under fault status press
key and check D group monitoring parameter ranging from D-00 to D-57.
If the fault wasn’t eliminated during checking the fault parameter, the interface will automatically switch to fault alarm
display 5s later after stopping operation.
The fault code displays ranging from D-48 to D-57 (the current status and latest 3 times).
3.8 Function Code Setting
The function parameter system of this inverter includes function code F0~FF, fault code E group and monitoring code D
group. Each function group is consisted of several function code, which is marked as (function group code + function
code). For example, “F5.08” means eighth function code in the fifth function group.
Function code setting example:
Example 1: change frequency setting of forward jogging form 5Hz to 10Hz (F1.20 modified from 5.00Hz to 10.00Hz)
①
Press
key to enter programming status, LED displays function code F0.00, flicker bit stays in the ones
digit.
②
Press
key, move the flicker bit among the hundreds place, tens place and ones place.
③
Press
key or
key to modify the digit in the according digit place. LED displays F1.20.
④
Press
key, it displays the according value (5.00) of F1.20, meanwhile the indicator light of unit Hz is on.
