Videx IP videokit IPVK/6296 Series, Руководство по установке

Страница: 23 / 76

66550062-EN - V6.0 - 31/10/21
- 23 -
IPVK/6296 Series IP videokit
IPVK/6296 Series - Installation handbook
ENABLE BOOTLOADER MODE
Fig. 21
Monitor in boot mode
27 mm 144 mm
182 mm
In case of firmware update failure (i.e. because of mains failure or cable dis-
connection during the update etc.) and the videophone is no longer recog-
nised by the Videx IP Wizard software, you can try to restore it by manually
putting it into boot mode.
It is strongly recommended that this operation is carried out by a qualified
engineer and in any case after contact with videx support.
• Disconnect the videophone from the power supply (ethernet connector if sup-
plied by POE or +12Vdc terminal connector if supplied by a power supply unit).
• Press and keep pressed button then connect again the power supply
source (ethernet connector if supplied by POE or +12Vdc terminal connec-
tor if supplied by a power supply unit).
• The videophone will go into boot mode which is indicated by the four LED’s
flashing alternatively (
Fig. 21
).
• Now proceed using the utility “VidexFirmwareUpdater.exe” to upload the
firmware to the device.
• If the update process terminates correctly, the device should be restored
and ready to work.
• If the device still does not work, please contact the supplier to proceed ac-
cording to the warranty terms.
CONNECTION TERMINALS SIGNALS
GNDI IN2 IN1
OUT2 OUT2 OUT1 OUT1
12V GND A B GND
GNDI
Ground for
IN1
and
IN2
inputs
IN2
Active low input 2
IN1 Active low input 1
OUT2
Relay 2
C & NO dry contacts
Max 35Vdc
50mA
OUT2
OUT1
Relay 1
C & NO dry contacts
OUT1
12V 12 Vdc - 300mA power supply input.
This is not used if the videophone is connected to a
POE Switch or Router
GND
A
RS-485 connection B
GND
TECHNICAL SPECIFICATIONS
Housing and mounting:
6200 Series - Surface
Push buttons:
4
Programming: Through touchscreen or PC Wizard
software
Controls:
Call tone volume
Display Brightness
Microphone volume
Power consumption:
Stand-by: 250mA
Operating 250mA
Working voltage: 12Vdc - 300mA or POE
Working temperature: -20 +60 °C
Art. 6296
3.5" touch screen videophone for IPure system