Videx IP videokit IPVK/6296 Series, Руководство по установке

Страница: 37 / 76

66550062-EN - V6.0 - 31/10/21
- 37 -
IPVK/6296 Series IP videokit
IPVK/6296 Series - Installation handbook
The “ SIP ” tab ( Fig. 23 ) allows to configure the door panel to work with third party SIP servers. Please refer to SIP server specification
to set all required parameters (“ CLIENT SETTINGS ”, “ VIDEO CODEC ” and “ AUDIO CODEC ” settoms). The door panel can work at the
same time with third party SIP server and with VIDEX Cloudnected APP. When a call starts, all involved devices will ring according to
cascade settings, the first device that answer will stop call to others. The “ DTMF ” section allows to set the transmission mode for the
DTMF tones and the DTMF to be used to trig Relay 1, Relay 2 and to switch Camera.
The “ RTSP HTTP ” tab ( Fig. 24 ) allows to configure the RTSP server and the HTTP server.
The Real Time Streaming Protocol (RTSP) is a network control protocol designed for use in entertainment and communications sys-
tems, and allows to interface the door panel video streaming with external devices RTSP compliant. Once the RTSP server is enabled
(normally, default settings don’t need to be changed but in case contact your system administrator for details), it is available the
video streaming at the url shown close to the label “Stream Url:”. The streaming is costantly available independently from the call.
The “HTTP” server allows to enable the interfacing with the built-in relays through http commands: once it is enabled like it is shown
in the picture of Fig. 24 , if I open the link “http://192.168.178.103/RELAY/1/TRIG “, I can trig the relay 1 of the door panel.
In addition to the triggering operations, are also available links to check the status of the two outputs and also the status of the two
inputs (i.e. for application where I need to check the status of a gate or a door etc.)
Please note , while the required parameters are not entered, the “ Apply All Changes ” button is disabled.
The “ ADVANCED ” tab ( Fig. 25 ) allows the operator to make ajustments for speech quality “ ECHO CANCELLATION “ section, for vid-
eo quality “ CAMERA SETTINGS ” section, for network connection quality “ KEEP ALIVE SETTINGS ” and allows to unlink the device
from VIDEX CLOUD. Please leave default settings if you don’t need to change them for a specific reason.
Note , to set third party SIP CLIENT, the device must be previously unlinked from VIDEX CLOUD.
Once all settings are made, click on the button “ Apply All Changes ” to transfer the configuration to the door panel and wait for the
notice “ Device correctly updated ”.
Repeat the same steps for all the outdoor panels 4533 connected to the system.
Fig. 23
Outdoor Panel 4533 - SIP CLIENT
Fig. 24
Outdoor Panel 4533 - RTSP / HTTP
Fig. 25
Outdoor Panel 4533 - ADVANCED SETTINGS
VX IP Wizard
Wizard configuration software for VIDEX IP System