Vicruns VD560 Series, Инструкция по эксплуатации

Страница: 212 / 222

Communication Protocol VD560 Series Inverter User Manual
- 208 -
Function code parameter address label rules:
By function block number and the label for the parameter address said rules:
High byte: F0 ~ FF (group F), A0 - AF (group A), 70-7 F (U) low byte: 00 to FF
Such as: F3-12, address represented as F30C;
Note:
FP groups: neither read the parameters, and do not change the parameters;
U group: only can read, do not change the parameters.
When some parameters in converter is in operation, do not change;Some parameters of the
frequency converter in any state, cannot be changed;Change function code parameters, but also pay
attention to the range of parameters, units, and related instructions.
In addition, frequent block because the EEPROM is stored, the service life of the block can reduce
the EEPROM, so some function code under the mode of communication, do not need to store, just
change the value of RAM.
If to F group of parameters, in order to realize the function, as long as this function code address high
F into 0 can be achieved.
If for A group of parameters, in order to realize the function, the function code as long as the address
of A high into 4 can be achieved.
Corresponding function code shown by the following address:
High byte: 00 ~ 0F (group F), 40 ~ 4F (group A), 50 ~ 5F (group b)
Low byte: 00 to FF
Such as:
Function code F3-12 in the block is not stored in the EEPROM, address for 030 c;
Function code block A0-05 is not stored in the EEPROM, address represented by 4005;
The address said can only do write RAM, do read, read, as invalid address.
For all the parameters, can also use the command code 7 h to implement this feature.
Stop/part operation parameters:
Parameter Address Parmaeter Description
1000H Communiccation set value(-10000~10000)(decimal)
1001H Running frequency
1002H Bus voltage
1003H Output voltage
1004H Output current
1005H Output power
1006H Output torque
1007H Running speed
1008H DI input sign
1009H
DO output sign
100AH
AI1voltage
100BH AI2voltage
100CH AI3 (expansion card) voltage
100DH Count value input
100EH length value input
100FH Load speed
1010H
PID setting
1011H PID feedback
1012H PLC step
1013H PULSE input pulse frequency, unit 0.01kHz
1014H Feedback speed, unit 0.1Hz
1015H Surplus running time
1016H AI1voltage before correction
1017H AI2 voltage before correction
1018H AI3 (expansion card) voltage before correction
1019H Linear speed