Vicruns VD560 Series, Инструкция по эксплуатации

Страница: 171 / 222

VD560 Series Inverter User Manual Parameter Description
- 167 -
+Aw
-Aw
Swing frequency amplitude
Aw=Fs et*Pb-52
Jumpi ng
frequency=Aw*Pb-53
Output frequency(Hz)
Swing frequency
upper li mit
Center frequency Fset
Swing frequency
lower li mit
Running frequency
Accelerat e according
to accel erat ion time
Swing frequency
cycle
Triangle wave
rise time
Decelerat e according to
deceleration ti me
Fig 6-31 Schematic diagram of swing frequency function
Fb-54 Swing Frequency Cycle 0.1s~3000.0s 10.0s
○
Fb-55
Triangular Wave of Swing
Frequency Rise Time
0.1%~100.0% 50.0%
○
Swing frequency cycle: a complete time value of swing frequency cycle.
Triangle wave rise time coefficient Fb-55, is a triangular wave rise time relative the time percentage of
the swing frequency cycle Fb-54.
Triangle wave rise time=swing frequency cycle Fb-54 x triangle wave rise time coefficient Fb-55, and
the unit is the second.
Triangle wave fall time=swing frequency cycle Fb-54 x (1-triangle wave rise time coefficient Fb-55),
unit for seconds.
Fb-56 Set Length 0m~65535m 1000m
○
Fb-57 Actual Length 0m~65535m 0m
○
Fb-58
Number of Pulse per
Meter
0.1~6553.5 100.0
○
The above function code is used to fixed-length control.
Length information need to be cpllect by the multi-function digital input terminals, terminal sampling
pulse number and the number of pulses per meter Fb-58 division, can calculate the actual length
Fb-57. When the actual length is greater than the set length Fb-56, multi-function digital DO output
"length reached" ON signal.
In the process of the fixed length control, through the multi-function DI terminals, for the length of the
reset operation (DI function selection for 47), specific please refer to the F5-00~F5-06.
In the application, need to set the corresponding input terminals function to "length counting input"
(function 46), when the pulse frequency is higher, must use HDI1 port.
Fb-59 Set Count Value 1~65535 1000
○
Fb-60 Designated Count Value 1~65535 1000
○
Count value need to be collect by the multi-function digital input terminals. In the application, need to