66
-
Push the bolt lightly and extract the
retainer from the milled part shown in the
figure.
-
Extract the bolt assembly from the lock
body.
-
To refit, follow the reverse procedure.
7.9.2
Removing the Steering Lock when on «LOCK» Position
The bolt retaining spring is not accessible in
the «LOCK» position. It is then necessary to
drill the bolt as shown in the figure to eject it.
Note:
To refit the bolt from this position, first
disengage the steering lock by putting the
lock body (inner and outer part) in the OFF
position.
To refit, proceed as described in the previous
paragraph.
Содержание GT 200
Страница 1: ......
Страница 90: ...90 9 1 2 Turn Signal Lights Horn Services and Accessory Pre Wiring ...
Страница 151: ...151 10 10 Lubrication Circuit ...
Страница 195: ...195 Remove the main jet Loosen the emulsion jet Tilt the carburetor and remove the emulsion jet ...