184
10.11.3
Checking the Crankshaft
-
Check the connecting rod axial clearance, before
removal.
Standard clearance:
Connecting rod (axial)
0.008-0.020 in
(
0.20-0.50 mm
)
-
Check the radial clearance on the connecting
rod.
Standard clearance:
Connecting rod (radial)
0.0014-0.0021 in
(
0.036-0.054 mm
)
-
Check that the surfaces that limit the axial free-
play are not scored and measure the width, as
shown in the figure.
Note:
Make sure the ends of the caliper do not go
into the machined corner of the crankshaft, as the
curvature in the corner may cause inaccurate
readings.
Standard dimension:
with shim adjusting washers
2.024-2.026 in
(
51.40-51.45 mm
)
Standard dimension:
2.192-2.199 in
with integral washers
(
55.67-55.85 mm
)
Warning
– The crankshaft can be re-used as long as its width is within the specified limits
and shows no signs of scoring.
-
If present, check that the shim adjusting washers show no signs of superficial
imperfections, such as scratches or crack initiations, and measure their thickness.
Standard dimension:
Shim adjusters thickness
0.0856-0.0876 in
(
2.175-2.225 mm
)
Note:
If the shim adjusting washers are to be reused, ensure to keep the initial assembly
position.
Содержание GT 200
Страница 1: ......
Страница 90: ...90 9 1 2 Turn Signal Lights Horn Services and Accessory Pre Wiring ...
Страница 151: ...151 10 10 Lubrication Circuit ...
Страница 195: ...195 Remove the main jet Loosen the emulsion jet Tilt the carburetor and remove the emulsion jet ...